This guy did it right with a remote control and leaving the 1030 with the hardware in a very neat and very OCD set up... Getting ready to start this build but going to remove the FujiNet SIO pins and replace with connection by wire the 1030 SIO to flatten out the FN. Everything else is on extension wires including the LED's and a 3D print of the remote for onto of the monitor or maybe even a-top the 1030.. Not sure yet? Wade your thoughts?
I like it. I'm not a fan of the remote, but I see its utility and value add. I need to finish the board I was working on. Time...
This guy did it right with a remote control and leaving the 1030 with the hardware in a very neat and very OCD set up... Getting ready to start this build but going to remove the FujiNet SIO pins and replace with connection by wire the 1030 SIO to flatten out the FN. Everything else is on extension wires including the LED's and a 3D print of the remote for onto of the monitor or maybe even a-top the 1030.. Not sure yet? Wade your thoughts?